AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Dcommand power supply9/9/2023 ![]() The available power is the lesser of the available power for power supply redundancy mode and input source redundancy mode. Full redundancy mode-This mode combines power supply redundancy and input source redundancy, which means that the chassis has an extra power supply and one half of each power supply is connected to one electrical grid while the other half of each power supply is connected to the other electrical grid.The available power is the amount of power provided by the active power supply units. The other one or two power supplies are active. The power supply that can supply the most power operates in standby mode. In case of a power-supply unit (PSU) failure, power will be limited to a user-defined value if PSU. Power supply redundancy mode-This mode provides an extra power supply in case an active power supply goes down. Solution ID: sk107672 Technical Level: Advanced Email Outputs of 'show sysenv all' and 'cpstat os -f powersupply' commands show different status for Power Supply units Product Quantum Appliances, Quantum Security Gateways Version R77 (EOL), R77.10 (EOL), R77.20 (EOL), R77.30 (EOL), R80.10 (EOL), R80. You can use the ipum-utils command to control power.The available power is the amount of power by the lesser of the two grids through the power supplies. show fc srp initiator guid extension Syntax Description. If one power grid goes down, each power supply continues to draw power through its other half module. To display the attributes of initiators that you have configured on your Server Switch, enter the show fc srp initiator command in User Exec mode or Privileged Exec mode. Input source redundancy mode-This mode utilizes two electrical grids, each one powering a half module within each power supply.The available power for this mode is the total power capacity of all power supplies. Combined mode-This mode does not provide power redundancy.You can configure the power supplies with the following modes: You can use the power redundancy-mode command only in the default virtual device context (VDC). The voltage and current waveforms on the load, at transfer power supply from mains power to inverter CH1-voltage (250V/div), CH2-load current (20A/div) TIME 25ms/div Figures - uploaded by Dr. ![]()
0 Comments
Read More
Leave a Reply. |